Raspberry Pi

  • Front Page
  • Latest pages
  • Latest comments
  1. Raspberry Pi
  2. Hardware
  3. Case & Mini HDMI

Case & Mini HDMI

The plug body is too large to fit in the hole in the case, made by the PiHut and so it can not sit far enough in, causing intermittent signal transfer if there's much of a vibration to the case or or workbench. Note the one for the power cable cut-away is fine.

View of port cut-aways
The white plug after cutting now fits

Trimmed down plug
I cut away some of the plastic, seemingly too much, but that allowed me to top the end with hard resin.

Trimmed down plug
I cut away some of the plastic, seemingly too much, but that allowed me to top the end with hard resin.

Mini HDMI plug in situ
Mini HDMI plug modified

Created by roger • Last edit by roger on 06/11/20 07:22 pm

No feedback yet


Form is loading...

Content Hierarchy

  • Hardware
    • The Beginnings
    • Case & Mini HDMI
    • Heat Sink
Content Mangement System

This collection ©2021 by roger • Contact • Help • Multiblog engine